Audio Note AN-K Bedienungsanleitung PDF herunterladen (Seite 26)

www.AudioNoteKits.com

Page 26

Start by taking the Negative side of the capacitor (stripe

side) and bend the leg into position and thread it through

the resistor hole.

Then you can solder the resistor and the capacitor leg and

the stranded wire together – be careful not to burn the

casing the capacitor.

You can also temporarily bend the capacitor out of the way

so you can make the solder connection and then bend it

back.

Once that is successfully connected, you can bend the

positive leg over to Pin 1 of the valve base.

Note that this leg needs to touch both pins 1 and 8 so you

can bend the leg to touch both pins of the valve base and

then solder them both - refer to the graphic to show this

connection.

Then do the same thing with the other capacitor – its

definitely tricky but take your time.

Make sure the Negative side of the capacitor will connect to

the resistor lead and the positive side to the valve base pins

1 & 8.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 57 58

Keine Kommentare

Audio Note AN-K Bedienungsanleitung Seite 26